Shop by looking at paint
- Look and touch the fullness of the paint film, you will see it after a few more comparisons. The fullness of the paint film means that the quality of the paint is good, the cohesion is strong, and the seal to the wood is good. At the same time, it means that the painting process is relatively complete, and there will be no suspicion of cutting corners.
- Stand on the oblique side of the door to find the reflective angle of the door, and check whether the paint film on the surface is smooth, whether the orange peel phenomenon is obvious, and whether there are small protruding particles. If the orange peel phenomenon is more obvious, it means that the paint film baking process is not up to standard.
- For fancy shaped doors, it depends on whether there is cracking of the paint film on the edges of the lines that produce the shape, especially the inner corners (that is, the corners that can be seen but not touched).
- Ask about the type of paint, and the basic answer is PU paint (polyurethane paint). Please note that the advantage of PU paint is that it is easy to polish and saves time and effort in the processing process. The disadvantage is that the paint film is soft, and slight bumps can easily produce white shadows. dent. If at least one layer of the paint layer is PE paint, this possibility will be greatly reduced. The advantages of PE paint (polyester paint) are that the paint film is hard, the hiding power is strong, the transparency is good, and it can better express the wood veneer texture. The disadvantage is that it is difficult to polish, and the processing process is time-consuming and laborious. Most manufacturers are unwilling to use PE coating.
Choose according to flatness
- The veneer is blistered, which means that the veneer is heated unevenly during the attachment process, or the glue is applied unevenly. The flat heat press machine can solve the problem of uneven heating when the flat door is pasted.
- The surface flatness of the wooden door is not enough, which means that the selection of boards is relatively cheap, and the flatness of the boards is not enough. It is conceivable that the environmental protection performance is also difficult to meet the standard, which is a bit like knowing the autumn.
look at the craft
See whether the process seams are uniform and small, which is similar to choosing a car, and directly reflects the comprehensive process level of the enterprise.
Look at the installation quality
Although the finished suit door is produced in the factory, it is considered as a finished product when it is handed over to customers for use. Therefore, the door product is only a semi-finished product when it leaves the factory, and installation is the key link. A good installation process, good installation tools, and experienced installation technicians are the key to the success of the installation.
Look at the hardware
Hardware is a matter that is easy for wooden door manufacturers to argue with customers in judging the quality of door products. Customers are advised not to purchase hardware components themselves. If the manufacturer cannot provide satisfactory hardware products, they must choose hardware from famous brand manufacturers. Products, such products are generally lifetime warranty.